How to setup Cakewalk Generic Surface for Korg nanoKontrol
Now being a devotee of Cakewalk (Sonar) I looked at adding a Control Surface in the form of an old Korg nanoKontrol (version 1). Long story short it worked and I now have a preset saved as a Cakewalk Generic Surface. The story for what its worth is as follows. The Korg nanoKontrol initially proved to be a problem in that it would not install correctly when using the Korg signed driver for Windows 10. You need to uninstall the Korg driver in Programs and Features, disconnect the nanoKontrol and restart. After restart check there is no app for Korg Driver in Windows Control panel. If the app persists then in Device Manager delete the driver again and restart. Now connect the nanoKontrol and it should now appear in Midi device lists for example in Midi-Ox. Now that the nanoKontrol was usable I mapped the Control addresses using Midi-Ox. Here’s the midi messages displayed by Midi-Ox after pressing RecArm and Mute buttons. The Data1 column displays the controller address in this case 0x17...